Connecting The Nes Control Deck To Your Tv

There are two alternative methods of connecting the NES Control Deck to your TV set, depending upon your type of TV:

EITHER: (1) Using the Audio/Video Cable;

OR: (2) Using the RF Switch and Converters.

First, compare your TV with the following illustrations (1), (2) (i) and (2) (ii) to determine which method you should use, (1) or (2). If you have a VCR connected to your TV, see Page 7.

(1) Using the Audio/Video Cable

Nintendo Have Switch But Vcr

BACK OF TV SET

AUDIO/VIDEO CABLE

SIDE VIEW OF CONTROL DECK

(Note! If your TV does not have direct audio/video connections, proceed directly to Method (2) "using the RF Switch and Converters".)

VHFCONNECTOR

VIDEO OUT JACK

VIDEO IN JACK AUDIO OUT JACK

AUDIO-IN JACK

To facilitate connection to video recorders, etc., many TV's have special audio/video input jacks. If your TV has such a jack, connect the audio/video cable supplied with the NES between the audio/ video-out jacks on the NES Control Deck and the audio/video-in jacks on your TV set, and then flick the switch located on your TV that changes the TV from antenna reception to direct audio/ video input. When you use the audio/video cable to connect the NES to your TV, there is no need to use the RF switch or converters, or to touch the antenna on the back of your TV. For more information on direct audio/video hook-ups to your TV, consult your TV Operation Manual.

(2) Using the RF Switch and Converters

(i) If your TV has two screws for (VHF) antenna connection, connect the RF switch and NES as shown below. If your TV has a VHF cable connector, please see Page 6.

VHF SCREWS

BACK OF T

ELEVISION SET

WITH 300/75 ft CONVERTER

75 ft CONNECTOR FROM TV ANTENNA OR CABLE TV

TWIN LEAD WIRE FROM OUTSIDE _J ANTENNA OR

RF SWITCH

75/300 ft CONVERTER

CONNECT TO RF SWITCH JACK

(SEE PAGE 2 FOR REAR VIEW OF CONTROL DECK)

(¡¡) If your TV has a VHF cable connector, connect the RF switch and NES as shown below.

VHF CABLE CONNECTOR ON

BACK OF TELEVISION SET

VHF CABLE CONNECTOR ON

BACK OF TELEVISION SET

Connect Nes Vhf
(SEE PAGE 2 FOR REAR VIEW OF CONTROL DECK)

NOTE: If a VCR is already connected between the antenna and the VHF terminals on the back of your TV set, the RF switch must be installed between the VCR and the TV as shown below:

(Refer to the sketches on Page 5 and 6 for your type of TV connection.)

IF THERE IS A CABLE CONNECTED BETWEEN THE VCR AND THE UHF TERMINAL ON THE BACK OF YOUR TV SET, LEAVE THAT CABLE AS IS.

Was this article helpful?

0 0

Responses

  • Tuomas
    How to wire a switch on nes?
    8 years ago

Post a comment